Mr. Spastic's Installation Video! :)
Thanks man!!!
(Print this out 1:1 ratio, When printed
you can use a ruler to see if it printed to the
correct size.)
(Your holes should look like this)
(You will need to cut out that post. I
Cut the tabs on each side first then
Ease into the bottom)
(You will also need to cut the tab
off the other post as shown here)
(the board fits, only requires a little bit
of muscle against the outer pannel a bit to
slide the pcb in (jacks first)) **BE CAREFUL WHEN TIGHTENING THE NUTS. YOU RISK
STRIPPING THE PLASTIC THREADS. I USE 6-8LBS TORK SETTING, NOTHING MORE!!!**
(Solder audio cable to resistors, Pre-tin first!)
(Pin 1 = PU 1&2 Pin 2 = Tri/Wav/Nos)
(Pending on how you wire it, you can chose which
channel will be on the normalled "Mono" output)
(I recommend hot gluing to avoid accidental shorting
or accidental break while moving the wire around)
(Add a small bit of solder to the joints you will
be soldering to. Be sure not to short these pins
or it will fry the 7805. It should look like this)
(Carefully route power over to board
and plug in audio and power cables.
Carefully re-assemble your NES)
